Facelift 2004 ---> 2008

[akacio]

[9] Central Electric (4E0 910 279 J) = 0133121
[55] Headlight Control (4E0 910 357) = 0000003

Good code or not ?

[Akin]

Try to encode a 55 unit: 0000018

Текст:

Coding

0000016 = Audi A6 (4F) with Steel Suspension
0000017 = Audi A6 (4F) with Air Suspension
0000018 = Audi A8 (4E)
0000019 = Audi A4 (8E)
0000020 = Audi A3 (8P)
0000021 = Audi Q7 (4L) with Steel Suspension
0000022 = Audi Q7 (4L) with Air Suspension
0000023 = Audi TT (8J) with Steel Suspension and Front Wheel Drive (FWD)
0000024 = Audi TT (8J) with Steel Suspension and All Wheel Drive (AWD)
0000025 = Audi TT (8J) with Magnetic Ride
Note: Perform Security Access before Coding and Basic Setting (Headlight Adjustment) after Coding!


Security Access

02000 = General Coding "Enabling"
02000 > 03000 > 04000 > 05000 = General Adaptation "Enabling" (Enter one after another)

Adaptation

Channel 020: Showroom Effect
After activating the showroom effect the dynamic cornering light at vehicle standstill can be demonstrated to the customer. The showroom effect remains active until the showroom effect is deactivated via the function program.

0 = Disabled
1 = Enabled
Channel 023: Tourist Solution
When driving in countries where driving is performed on the opposite side as in the native country the headlights must be changed over to avoid blinding the oncoming traffic.

0 = Disabled
1 = Enabled

Basic Setting

Headlight Adjustment
[Select]
[55 - Xenon Range]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
Adjust the headlights using their manual adjusting rews as referenced against a suitable aiming target.
[ON/OFF/Next]
The adjustment should now be learned.
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]

[akacio]

Hi Akin,

You said that if i install 10 pins headlights i have just to recode and " ADD RESISTANCE IN THE DIMENSIONS

I don't understand. What do you mean by " ADD RESISTANCE IN THE DIMENSIONS ?